M&P 2.0 Forced Reset Device

M&P® 2.0 forced reset device

The M&P® 2.0 Device is a forced-reset style component designed specifically for the Smith & Wesson® M&P® 2.0 platform. This unit installs at the rear of the slide, replacing the factory backplate for straightforward installation and removal.

These are not drop in parts, and require polishing and fitting, to fit, and function like butter.

In the event the forced reset function does not engage, the pistol will continue to operate in standard semi-automatic mode.

⚠️ Important: This device disables the factory striker safety plunger. Use at your own risk.

Material & Finish:

Manufactured from 316 stainless steel

Supplied in a raw, unfinished state

Tuning, polishing, and fitting are required for proper function

These are not drop-in parts

Final fitment will vary by pistol, frame, and component tolerances

Compatibility

Works with:

Smith & Wesson® M&P® 2.0

9mm / 10mm / .40 S&W / .45 ACP

Full Size, Compact, Subcompact

Metal Frame, Performance Center, and Thumb Safety models

Does NOT work with:

M&P® 1.0

Shield, SD, or Bodyguard models

Apex Forward Set Sear Actuator

Installation & Tuning Notes

Fitting is required for best performance

“Slight rounding of an edge on the trigger bar is recommended

A 4 lb striker spring is recommended

A heavier recoil spring is recommended only if reset issues occur

Most clean, properly lubricated pistols run with the factory recoil spring

.45 ACP and 10mm models typically require a 22–24 lb recoil spring

Warning & Liability Disclaimer:

By purchasing or using this product, the user accepts full responsibility for proper installation, tuning, function testing, and safe operation. Improper installation, insufficient fitting, or misuse may result in unintended discharge, serious injury, or death. The manufacturer assumes no responsibility for damage, injury, or loss resulting from use or misuse of this product. There are no refunds on parts unless stated otherwise